1、首先用起重工具將榮凱登車橋http://m.iyunsun.com/電纜卷懸掛于電纜筒上方，放出約2.5米的電纜，以便把電纜接到電源箱上。
First with the wing lifting axle Kadant cable suspended above the cable drum roll, the release of about 2.5 meters of cable for the cable to the power supply box.
 
2、其次從登車橋電纜筒底部拉出電纜至電源箱，暫不要連接；將電纜一圈一圈順時針放入電纜筒中，盡量使每圈一樣大，其直徑略小于電纜筒直徑；將電纜固定在電纜托架上，將電纜插頭插入插座；將電纜接至電源箱上，啟動登車橋檢查電纜是否纏繞。
Secondly pulled from the bottom of the dock leveler cable drum cable to the power supply box, temporarily do not connect; clockwise circle around the cable into the cable drum, try to make each lap as big a diameter slightly smaller than the diameter of the cable drum; the cable fixed on cable trays, cable plug into the outlet; the cables to the power supply box, start Ramps check the cable is wound.
　　
3、然后在登車橋http://m.iyunsun.com/導軌架加高的過程中要同時安裝電纜保護架，調整電纜保護架以及電纜托架的位置，確保電纜在電纜保護架“U”形中心。
Ramps and rails in the rack heightening process to install the cable protection bracket, adjust the position of the cable protection frame and cable tray, make sure the cable in the cable protection frame "U" shaped center.